|
/
|
|
|
|
|
AVI-Gallery contains more than 150 animations illustrating analysis results obtained with use of ANSYS and LS-DYNA FE software.
AVI-Gallery
|
|
|
|
|
|
|
|
|
|
 |
|
|
CompMechLab ANSYS/LS-DYNA AVI-Gallery
In this section the materials about CompMechLab research projects are presented. All rights are reserved. No one can use any part of these materials in their personal interests without CompMechLab permission.
 |
Finite Element simulation of the PET bottle blow molding and non-linear buckling
|
| Keywords: |
PET, Polyethylene terephthalate, bottle, plastic, injection stretch blow molding, preform, internal pressure test, top load test, buckling |
| Category: | |
| Element Type/Problem Type: |
3D nonlinear thermoviscoelastic problem with contact interaction; non-linear buckling analysis |
| External loads: |
internal pressure, stretching rod, top load |
| Software: |
ANSYS, LS-DYNA, Blow molding simulation software |
| Year: |
2008 |
| Rating: |
3.14 (Votes: 112) |
| Reads: 7068 |
|
Non-linear buckling analysis under top load
side view
top view
Thermoviscoelastic simulation of blow molding
side view
Liked it? See details of this project. Read more on the subject:
[ Back ]
|
| |
